Using Various Types Of Paper - Ricoh MPC 1800 Quick Manual

2 Troubleshooting

Using Various Types of Paper

The example procedure that follows explains how to specify A4 glossy paper and load it in the one-sheet
bypass tray.
⋅ For details about Loading Paper, see p. 11, "Changing the Paper Size" or step3 on p. 23, "Printing onto
Envelopes".
⋅ The paper type determines which tray you must load the paper on. Use the following table to select the
correct tray for your paper.
Paper Type
Glossy paper, Thick glossy paper
Thick paper
Special paper, Preprinted paper
⋅ The bypass tray can automatically detect the following paper sizes:
A3L, B4L, A4L, B5L, A5L, B6L, 11 x 17 L, 8
If you load paper of a size that is not listed above, be sure to specify the paper size by using the
following procedure:
⋅ Note that the one-sheet bypass tray cannot automatically detect paper sizes.
⋅ Only the RPCS printer driver supports printing on glossy paper or thick glossy paper.
⋅ Settings remain valid until they are reset. After printing on glossy paper, thick glossy paper, thick
paper, special paper, or preprinted paper, be sure to clear the settings for the next user.
⋅ When using the one-sheet bypass tray or bypass tray for copying, you can specify the paper size and
paper type by pressing the {q} key. For details about settings, see p. 29, "Copying onto Envelopes".
Press the {User Tools/Counter} key.
Select [System Settings] using { U }
or { T } , and then press the {OK} key.
Select [Tray Paper Settings] using
{ U } or { T } , and then press the {OK}
key.
Select [Paper Size: 1-Sheet Bypass]
using { U } or { T } , and then press the
{OK} key.
Select [A4K] using { U } or { T } ,
and then press the {OK} key.
The "Programmed" message appears.
12
Where paper is placed
One-sheet bypass tray
Bypass tray, One-sheet bypass tray (thicker than 162 g/m
Tray 1, Tray 2, Tray 3, Bypass tray, One-sheet bypass tray
1 / x 11L, 5
2
2 )
1 / x 8 1 / L
2 2
BDZ003S