Dl Appliance Configuration Wizard - Dell DL1000 Deployment Manual

NOTE: Deselect Configure SNMP on this appliance if you do not want to set up SNMP details
and alerts on the appliance and skip to step 6.
2. In Communities, enter one or more SNMP community names.
Use commas to separate multiple community names.
3. In Accept SNMP packets from these hosts, enter the names of hosts with which the appliance can
communicate.
Separate the host names with commas, or leave it blank to allow communication with all hosts.
4. To configure SNMP alerts, enter the Community Name and the Trap destinations for the SNMP
alerts and click Add.
Repeat this step to add more SNMP addresses.
5. To remove a configured SNMP address, in Configured SNMP addresses, select the appropriate SNMP
address and click Remove.
6. Click Next.
The Thank You page is displayed.
7. To complete the configuration, click Next.
8. Click Exit on the Configuration Complete page.
The Core console opens on your default web browser.
Provisioning Storage
To complete disk provisioning for all available storage to create a new AppAssure Repository:
1. On the Provisioning page, Click next.
The Provisioning page displays available storage capacity for provisioning. This capacity is used to
create a new AppAssure Repository.
NOTE: For the DL1000 3 TB (2 VM) configuration system, you can allocate disk space to the
Standby VMs.
The disk provisioning for your system is completed and a new repository is created.
2. Click Next.
The Configuration Complete page is displayed, click Exit.

DL Appliance Configuration Wizard

NOTE: You see the DL Appliance Configuration Wizard only when you upgrade your appliance
using the latest RUU.
CAUTION: Make sure you complete all the steps of DL Appliance Configuration Wizard before
performing any other task or change any settings on the Appliance. Do not make any changes
through the Control Panel, use Microsoft Windows Update, update Rapid Recovery software or
install licenses, until the wizard is complete. The Windows update service is disabled temporarily
during the configuration process. Exiting the DL Appliance Configuration Wizard before it is
complete may cause errors in system operation.
The DL Appliance Configuration wizard guides you through the following steps to configure the software
on the appliance:
• Configuring the network Interface
• Registration and Host settings
• Alerts and Monitoring
17