Dell DL1000 Deployment Manual page 18

• Access and Management
• Configuring Windows backup
• Storage provisioning
• Configuring Retention policy and update options
NOTE: After you complete the Appliance configuration, you can either skip the wizard or continue
performing Machine protection, Replication, Virtual Machine Exports/Standby. If you choose to
skip the wizard, the Core Console launches automatically and you can perform machine protection,
replication, and virtual machine Exports at the later stages.
For more information on performing machine protection, replication, and virtual machine Exports see
Rapid Recovery on DL Appliances User's Guide at www.dell.com/support/home.
Configuring the network interface
To configure the available network interfaces:
1. On the DL Appliance Configuration Wizard Welcome screen, click Next.
The License Agreement page is displayed.
2. To accept the agreement, click I accept license agreement, and then click Next.
The Network Settings page displays the available connected network interfaces.
3. If necessary, connect extra network interfaces and click Refresh.
The additional connected network interfaces are displayed.
4. Select the appropriate network interfaces that are suitable for your environment.
You have the following options: IPV4 and IPV6.
The network details are displayed depending on the internet protocol you select.
5. To enable IPV4, select Enable an IPv4 interface.
a. To assign the internet protocol details for IPV4 interface, do one of the following:
• To assign the selected internet protocol details automatically, select Obtain an IPV4 address
automatically.
• To assign the network connection manually, select Set manually IPV4 address and enter the
following details:
– IPv4 Address
– Subnet mask
– Default Gateway
6. To enable IPV6, select Enable an IPv6 interface
a. To assign the internet protocol details for IPV6 interface, do one of the following:
• To assign the selected internet protocol details automatically, select Obtain an IPV6 address
automatically.
• To assign the network connection manually, select Set manually IPV6 address and enter the
following details:
– IPv6 Address
– Subnet prefix length
– Default Gateway
7. To enable NIC teaming, select Enable NIC teaming.
For information on NIC teaming, see
8. Click Next.
18
Teaming Network Adapters.