Garmin G500 Reference Manual page 52

MAP GROUP
ADS-B Target Selection
Traffic targets displayed on the dedicated traffic page may be selected in order
to obtain additional information about a traffic target.
1) Press the small MFD knob to start target selection.
2) Turn the small or large MFD knobs to step through selection of the available
targets.
3) Press the small MFD knob to stop target selection. Press the DESELECT key to
stop selection and/or clear target selection.
ADS-B Status
ADS-B Status displays the current status of traffic application: Off, Surface,
Airborne, Fail, Test, or N/A.
TAS/TCAS/TCAD Status
This shows the current operating mode/status of an interfaced TAS/TCAS/
TCAD system: STBY, GND, APR, OPER, or FAIL.
ADS-B Motion Vector
When Absolute Motion Vectors are selected, the vectors extending from the
traffic targets depict the target reported track and speed over the ground. When
Relative Motion Vectors are selected, the vectors extending from the traffic targets
display how the traffic target is moving relative to your aircraft. These vectors are
calculated using the traffic target' s track and ground speed and your aircraft' s track
and ground speed. These two values are combined to depict where the traffic target
is moving purely with respect to your aircraft and give a forecast of where the traffic
target will be, relative to your aircraft, in the near future.
NOTE: Absolute motion vectors are the same color as the traffic target.
Relative motion vectors are yellow for TAs and otherwise are green. The
annunciation on the bottom of the dedicated traffic page indicates which
vector type is selected and their length.
NOTE: Relative motion vectors are not available on the ground.
40
G500/G600 Cockpit Reference Guide
190-00601-03 Rev H