Standard Housing-C: For use with other accessories when waterproofing is not required
Installation Method:
1. Hold the bottom of the locking arm and flip up to open it.
3. Install the housing mount on the desired accessory and use the
setscrew to tighten.
1
2
2. Open the locking arm of the standard housing and place the camera inside
housing as shown in diagram below. Press the top cover of the fixed mount
around camera to close it. Press the bottom of the lock as shown in diagram
below until locked into place.
4. Use the included accessories tool to fully tighten the setscrew. Be careful not
to over tighten screw and risk stripping.
Accessories Tool
58