Kodak PIXPRO ORBIT360 4K User Manual page 34

Installing the Battery:
Use a screwdriver to remove the screw on the backside of the remote control by turning it counterclockwise (Fig. 1). Open the battery cover and insert the
battery (Fig. 2), close the battery cover and rotate the screw in the opposite direction to tighten down.
Screw
Installation of the Remote Control Mount-B /Mini Remote Control/3-Leg Stand:
1. Press the Mini Remote Control mount onto the 3-Leg Stand (Fig. 1). Close the tripod (Fig. 2).
Align the mount anchor point with the tripod anchor point.
2. To mount the Mini Remote Control and align it between the two location holes at the bottom of the mount (Fig. 3), align the remote control with the two
locating points at the top of the mount (Fig. 4), and snap into place.
Mount Anchor Point
(1)
Negative
Battery Cover
(2)
Locating point
(3) (4)
33