Launching The User Interface - Cisco BWX360 Installation Manual

Cisco BWX360 WiMAX Outdoor Modem / engbt / 253306943 / Installation.fm / 07.04.2010
Installing the Cisco BWX360 WiMAX Outdoor Modem
3. During the startup procedure, check the LED display on the indoor unit (see "Indoor
unit" on page 7). The following signify a successful system start:
– The ON power supply LED lights up green, and the Cisco BWX360 WiMAX Out-
door Modem starts a self-test.
– The FAULT LED (red) and the CONNECT LED (green) light up for approximately
1 second and then go out.
– If the connection to the outdoor modem is then found to be free from errors, the
CONNECT LED is continuously lit up green.
If an error occurs, the FAULT and CONNECT LEDs start to flash alternately at
regular intervals.

Launching the user interface

1. Open your Web browser.
2. Enter the IP address of the Cisco BWX360 WiMAX Outdoor Modem in the
browser's address field:
http://192.168.2.1
3. Press Enter (Return).
Login
If a system password has been set up on the Cisco BWX360 WiMAX Outdoor Modem,
the login screen will now open.
1. Enter the system password supplied by your provider in the text box and clickOk.
The start page of the user interface opens, in which you can change the language
if necessary.
If no system password has been set up on your Cisco BWX360 WiMAX Outdoor
Modem, a security warning will appear first. You should then assign a system pass-
word as soon as possible.
2. Confirm the security warning with Ok.
The user interface start page opens.
If the login screen does not open:
Check the connections and the PC configuration. For details, refer to the user guide
for the Cisco BWX360 WiMAX Outdoor Modem.
If you use a firewall it must allow connection to the Cisco BWX360 WiMAX Outdoor
Modem. For details, refer to the user guide for your firewall. If necessary, deactivate
the firewall while you configure the Cisco BWX360 WiMAX Outdoor Modem.
18