Stihl HL-KM Instruction Manual page 13

English
~
f-----;
• Attach the carabiner (1) to the
carrying ring (2) - hold the carrying
ring steady.
• Check that the carabiner is at about
hip height - adjust if necessary.
Detaching the unit from the harness
1
• Press down the bar on the
carabiner (1) and pull the carrying
ring (2) out of the carabiner.
12
Starting the Engine
Always follow the oper.ting instructions
for the KombiEngine and basic power
tool.
• Position the unit securely for
starting:
It
must rest on the machine
support and the blade gearbox.
• On units with adjustable cutter bar:
Set the cutter bar to the straight (0')
position.
• RemtMHhe blade scabbard. Check
that the cutting blades are not
touching the ground or any other
obstacles. If necessary, rest the
gearbox on a raised support (e.g,
mound, brick or something similar).
• Make sure you have a safe and
secure footing.
• Hold the unit firmly on the ground
with your left hand and press down
- do not touch the throttle trigger or
interlock lever.
I
~
I
Do not stand or kneel on the drive
"'" tube.
I/'
The cutting attachment may begin
~ to move as soon as the engine
starts. For this reason, blip the
throttle after starting - the engine
returns to idling speed.
The start'lng procedure is now as
described in the instruction manual of
the KombiEngine or basic power tool
you are using.
Shut off the engine.
• See instruction manual of the
KombiEngine or basic power tool.
HL-KM
f
Ii
I