Connector And Cable Assembly - Gill Instruments Windobserver 65 User Manual

Gill Instruments Ltd
_____________________________________________________________________________________________________________
5.4.

Connector and Cable Assembly.

The WindObserver 65 variant with a connector base is supplied with a mating 19 way
connector.
Open the pack of connector parts supplied (Gill Part 1390-10-163).
A set of assembly instructions are supplied with the connector together with:-.
Part Name
Connector head, 19 way
Metal backshell (7 pieces)
Solder bucket contacts
(5 per pack, (4 –off packs))
Arrange Backshell (Gill Part Number 020-04465).
Pass parts 1-6 along the cable as per the diagram below.
(Note that the connector supplies the correct strain relief for cables with an outside
diameter of 7.9 to 12.6mm).
Part 7 Part 6
Prepare Cable (e.g. Gill Part 026-026643).
Trim back the cable outer and twisted pair screen sleeves 40mm (see diagram below).
Trim back the screen drain wires to a length of 24mm.
Strip back the connection wires by 7.1mm and tin solder.
Solder the wires to the bucket contacts (will take 14awg to 26awg wire).
Unused wires should be cut back and insulated.
7.1mm
Prepare Connector Head (Gill Part 020-04464).
Remove the connector thread protector and place the O-ring (part 7) into the groove of the
connector head (020-04464).
O-Ring to be placed here
Remove the thread protector
________________________________________________________________________________________________
WindObserver 65
Doc. No. 1390-PS-0039
Table of Equivalent Part Numbers
Gill Part No.
020-04464
020-04465
020-04469
Part 5
Screen Twisted Pair Cable
24mm
40 mm
Cannon Trident Part No.
Part 4 Part 3
Screen drain wires
Page 9
192993-0054
192993-0084
192900-0635
Part 2 Part 1
Issue 4
June 2016