360° Flip - Kaiser Baas Alpha Drone Complete User Manual

19
Trimming (Fine Tuning)
Control of the Alpha Drone can be trimmed
using the fine-tuning buttons on the
Remote Control Transmitter. If the Alpha
Drone is drifting off during a hover or other
flight manoeuvre, these buttons are used
to counter this drift.
The calibration is displayed on the display
screen of the Remote Control Transmitter.
You will see the trimming levels displayed
in the fine tuning bars on the display which
will show in which direction the drone
controls have been trimmed.
To reset all trimming and calibration, hold
the Reset button for five seconds.
TIP - Pressing the High/Low button
again will return the sensitivity level
to the lowest setting.
360° Flip
To perform a forward flip press the
Flip button!
The drone will launch forward and
descend during the flip so make sure
that the drone is at an adequate height
before performing this manoeuvre.
Advanced Flip Mode
The Drone also features an advanced
flip mode that will enable it to flip in all
directions.
To use this feature, toggle the through
the High/Low settings until you reach
100%; the Remote Control Transmitter
will emit 4 consecutive beeps.
The drone will emit a beeping sound
while the throttle has power. This
indicates that whilst in this mode the
Right Stick will let you flip the drone
in any direction.
When the Right Stick is pushed to its
extreme in any direction, the drone will
flip accordingly. Please note the
sensitivity is increased and this mode
is for advanced pilots.
Ensure you have given the drone at least
5 metres of clearance.
To return back to normal flight
mode,press the High/Low button toggle.
20