Installing The Casing Cover - BMW i wallbox connect Installation Instructions Manual

Installing the casing cover

Note
This cover is not essential for the safe operation of the Wallbox.
42
Casing marking
1. Tighten the four bolts until the casing markings
at right and left on the connector panel cover
close flush with the casing.
2. The connector panel cover must be correctly
sealed by the casing.
For self-tapping bolts, an increased torque
application is required: 2.58 ft·lb.
Attaching the casing cover
1. Attach the casing cover at the top, and ensure
that the hooks of the casing cover are correctly
inserted 1.
2. Press the cover downwards, and then tilt the
casing cover 2 towards the back.
The casing cover must slide into the lower
guides with very little resistance.
ATTENTION
Ensure that the casing cover sits correctly
into the casing guide on all sides. Only a
small uniform gap should be present.