Optional Transport Trolley; Switching Off; Working With The Power Tool; Transport - Hilti TE 2000-AVR Operating Instructions Manual

5.2.2 Switching off

1. Press the on/off switch.
2. Unplug the supply cord from the power outlet.

5.2.3 Working with the power tool

Note
The chisel can be adjusted to 6 different positions (in 60° increments). This ensures that flat chisels
and shaped chisels can always be set to the optimum working position.
▶ Bring the chisel into contact with the workpiece about 80 -100 mm (3¹⁄₈" - 4") from its edge.
▶ When working close to reinforcing bars, always guide the tip of the chisel toward the edge of the
workpiece, not toward a reinforcing bar.
▶ Begin with the chisel positioned at an angle of 70° to 80° to the concrete surface, with the tip of the chisel
pointing toward the edge of the workpiece. Break material away by subsequently increasing the angle to
approx. 90° as the chisel penetrates.
▶ Rotate the chisel regularly to help ensure even wear and to promote the self-sharpening process.
▶ If inadequate pressure is applied, the chisel will jump around uncontrollably. Application of excessive
pressure will result in a loss of chiseling performance.

6 Optional transport trolley

6.1 Transport

The transport trolley helps to ensure that the breaker can be transported safely.
• Take care to ensure that the transport trolley stands in a steady, secure position.
• Place the power tool on the locating pin provided on the transport trolley and always secure it for
transport by closing the retaining bar.
Printed: 17.02.2017 | Doc-Nr: PUB / 5333067 / 000 / 00
English 11