Important notes:
Wait for the Schlage button LEDs to stop flashing before continuing to the next step.
L
Programming mode will time out if no entry is made in 20-25 seconds. Time out is
L
indicated by three left and nine right red blinks of the Schlage button.
An incorrect entry is indicated by a solid red left and blinking green right LED
L
on the Schlage button. Refer to Error codes on page 12 to interpret error code
patterns.
A unique credential must be used for each credential type (for example, a single
L
credential may not be used for both normal use and toggle functions).
PROGRAMMING credentials
To complete this
action:
Create new
Programming
Code (PIN)
Create new
Programming Card
Manual programming instructions
Wait for
1
Enter
(This is the default
programming PIN)
Enter
Perform the following steps:
to stop flashing between each step!
2
Enter new 5 digit
Enter
Programming
code and
Wait for right
green light.
Present new
Enter
programming card.
3
Reenter the new 5
digit Programming
code and
Wait for confirmation:
2 right green blinks.
Wait for confirmation:
2 right green blinks.
7 • Schlage • AD-200 user guide
4