Manual Programming Commands - Schlage CO-100 User Manual

CO-100 Offl ine Lock User Guide

Manual Programming Commands

Commands are confi rmed by fi ve alternating green blinks of the Schlage button.
Programming mode will time out if no entry is made in 20-25 seconds. Timeout is indicated by red
blinks of the Schlage button, three left and nine right at the same time.
The right LED on the Schlage button will blink green to indicate an incorrect entry. To interpret
blink patterns, refer to Error Codes on page 7.
Function
Change
[Programming Code]
Add Normal Use
PIN
Add Toggle PIN
Add Freeze PIN
Add Pass-Through
PIN
Delete a PIN
Change Relock
Time
1 Other lights may show before the fi nal confi rmation. Wait for fi nal confi rmation before continuing to the next step.
2 Change PIN length is available with fi rmware version 2.5.0 or higher.
[Programming Code]
New [Programming Code]
New [Programming Code]
[Programming Code]
New [PIN]
add another PIN
[Programming Code]
New [PIN]
add another PIN
[Programming Code]
New [PIN]
add another PIN
[Programming Code]
New [PIN]
add another PIN
[Programming Code]
[PIN] to be deleted
[Programming Code]
Each button press adds to the total delay time
Example: +
Press
OR
to finish
OR
to finish
OR
to finish
OR
to finish
to finish
adds a 10 second delay
to finish
6
Wait For
Confi rmation 1
Wait for
to stop flashing
between each
step.
Wait for
to stop flashing
between each
step.
Wait for
to stop flashing
between each
step.
Wait for
to stop flashing
between each
step.
Wait for
to stop flashing
between each
step.
Wait for
to stop flashing
between each
step.
Wait for
to stop flashing
between each
step.