Cisco Nexus 9396PX Hardware Installation Manual page 13

Overview
1 Console port (RS232 port)
2 Chassis LEDs
3 Two USB ports used for saving or copying
functions
Note
4 Out-of-band management port (RJ-45 port)
5 48 1- and 10-Gigabit Ethernet Small Form-Factor
Plugable (SFP+) optical ports (supporting
1-Gigabit and 10-Gigabit speeds) to switches or
Fabric Extenders (FEXs)
To determine which transceivers, adapters, and cables are supported by this switch, see the
Modules Compatibility Information
The following figure shows the hardware features seen from the fan side of the chassis.
• Beacon (BCN)
• Status (STS)
• Environment (ENV)
USB support is limited to USB 2.0
devices that use less than 2.5 W (less
than 0.5 A inclusive of surge current).
Devices, such as external hard drives,
that instantaneously draw more than 0.5
A are not supported.
6 M6PQ, M6PQ-E or M12PQ uplink module
(M12PQ uplink module shown).
7 6- or 12-port 40-Gigabit Ethernet Quad Small
Form-Factor Plugable (QSFP+) optical ports for
connections to other devices (12-port uplink
module shown)
8 Notch in both sides of the chassis for locking the
power supply end of the chassis to the
bottom-support rails
9 Screw holes (4) for attaching a center-mount rack
bracket for two-post racks (one bracket for each
of two sides)
10 Screw holes (2) for attaching a front-mount
bracket for four-post racks (one bracket on each
of two sides)
document.
Cisco Nexus 9396PX NX-OS Mode Switch Hardware Installation Guide
Overview
Cisco Transceiver
3