Installation - Audiovox Jensen A34XP Installating And Operation Manual

A34XP & A46XP

Installation

Before You Begin
To install the amplifiers, you will need tools, supplies and adapters. It is best to make sure you
have everything you need before you start.
Supplies and Tools Needed
Supplies
• Black electrical tape
• Amplifier Installation Kit
Tools
• Cordless drill with assortment of bits
• Flat-head and Phillips screwdrivers
• Wire cutters/strippers
• Crimping tool
• 12-volt test light or digital multimeter
• Wire brush, sandpaper or scraping tool (ground connection to vehicle should be a clean,
unpainted metal surface)
Disconnect Battery
Before you begin, always disconnect the battery negative terminal.
Location and Mounting
The AXP amplifier's compact design allows greater flexibility in mounting. It can be mounted
under a seat or in the trunk.
When selecting a location, remember that amplifiers generate heat. Select a location where air
can circulate around the amplifier. Do not cover the amplifier with carpets or enclose it behind
interior trim panels.
Do not mount the amplifier in an inverted or upside down configuration. Every installation will be a
bit different based upon vehicle design. Check all locations and placements carefully before
making cuts or connections.
Note: It is very important to allow air circulation around the amplifier.
Routing Wires
Proper wiring connections are illustrated in the Routing Wires diagram.
Note: If wiring connections are made incorrectly, the unit will not operate properly and
could become permanently damaged. Follow the installation instructions carefully, or
have the installation completed by an experienced technician.
Circuito de Ubicación de los Cables
3
Routing Wires
Cablage