Foppapedretti MYO Tronic Assembly Instructions Manual page 33

GB
USE
FOLDING THE PUSHCHAIR (fig. 54-58)
Before folding the pushchair, the seat must be removed.
Remove the seat, see the paragraph on "releasing the seat".
Remove the bumper bar from the seat, see the paragraph on "fitting the bumper bar".
Remove the hood, see the paragraph on "fitting the hood".
Press the seat backrest adjustment lever and fold the backrest down towards the seat, (fig 54).
Insert the seat, the bumper bar and the hood inside the carry bag (fig 55).
Lift lever "A" and keeping it raised, fold the handlebar back, see (fig. 56)
Lift the folding lever on the pushchair chassis "A" and fold down the chassis towards the front. A
click will show that the pushchair has been folded correctly (fig. 57, 58).
NOTE: It is NOT possible to fold the pushchair when the accessories such as the car seat and the
carrycot are fastened to the chassis.
ELECTRICAL OPERATION (pag. 10)
The pushchair can be pushed manually or electrically. The pushchair can be changed from
electrically-operated to manual operation at any time.
FITTING THE BATTERY
Insert the battery on the chassis, as shown in the diagram. Two clicks will indicate that it has been
connected correctly.
REMOVING THE BATTERY
Press buttons "A" and remove the battery.
SWITCHING ON
Make sure that the parking brake is off (fig. 7 pag. 10).
Turn the accelerator handle to position "low speed" (fig. 8 pag. 10).
Slowly push the pushchair forwards and at the same time press both the power buttons as shown
in the diagram (fig. 9 pag. 10) and keep them pressed. There is a delay of a few seconds before
the electric motors starts. To increase the speed turn the accelerator handle downwards. If the
accelerator handle is turned keeping both the buttons pressed, the speed is changed without any
interruption to the electrical operation. If both or just one of the buttons is released while the
accelerator handle is turned, the electric motor stops and starts again when both the buttons are
pressed.
To reduce the speed, turn the accelerator handle upwards.
MYO TRONIC 33