My Heos Device Turns Off And The Status Led Flashes In Red - Denon HEOS Owner's Manual

Contents

My HEOS device turns off and the status LED flashes in red

The protection circuit has been activated due to a rise in temperature within your HEOS device. Turn the power off, wait about
0
an hour until this device cools down sufficiently, and then turn the power on again.
Music cuts out or delays sometimes
Make sure your Internet connection is operating correctly. If you are sharing your network with other users or devices, they may
0
be using most of your bandwidth (especially if they are streaming video).
Make sure your HEOS devices are within range of your wireless network.
0
Make sure your HEOS devices are not located near other electronic devices that could interfere with it's wireless connectivity
0
(like microwave ovens, cordless phones, TVs, etc...).
I hear a delay when using the external input with my TV
If you are connecting the External input with your cable or satellite box for enjoying TV audio through multiple HEOS devices,
0
you may hear a delay between when you see someone speak and when you hear the audio. This is because the HEOS system
must buffer the audio before it sends it out to the HEOS devices so that it arrives at all devices at the same time.
You can avoid this delay by listening only to the device which is directly connected to the set top box.
0
Setup Use
Solution
Solution
Solution
Troubleshooting
64
Status LED Appendix
Refer to Page
Refer to Page
Refer to Page
–
7
60
60
－
－