Initial Setup; Om-1000 Bt Interface Cable Connections - Datalogic lynx bt Reference Manual

INITIAL SETUP

3 INITIAL SETUP
This procedure allows setting up the reader to operate with the default settings.
Two different procedures are available according to the type of application you are
working with:
−
Lynx™ BT paired to the OM-1000 BT (follow procedure in par. 3.2);
−
Lynx™ BT communicating with a Bluetooth
par. 3.3).
Whenever you need to change the default values refer to par. 4.2.
3.1

OM-1000 BT INTERFACE CABLE CONNECTIONS

The OM-1000™ can be connected to a Host by means of an RS232, Wedge or USB
cable which must be simply plugged into the Host connector, visible on the rear panel
of the cradle.
To disconnect the cable, insert a paper clip or other similar objects into the hole
corresponding to the Host connector on the body of the cradle. Push down on the clip
while unplugging the cable. Refer to the following figure:
Power
Multi-standard interface
RS232, WEDGE, or USB
to Host
Figure 4 – Connecting/Disconnecting the Cable
®
device (follow procedure in
3
13