Table of Contents
Advertisement
A
Command
$+
Enter configuration environment
Example:
Multiple command programming sequence for Lynx™ BT with BT device:
$+
GBB1
GBA1
ACA1ACC014ACC255
Beeper low intensity
Enter configuration environment
Each configuration parameter setting removes the condition previously active for that
parameter.
The device buffer can contain about 400 characters. If your
programming string goes over this value, you must split it into separate
groups and send each group after a delay of at least 3 seconds to give
the reader time to empty the buffer and interpret the commands.
NOTE
Configuring some configuration commands, such as those of
advanced formatting, through strings may result very complex. For this
reason they are not provided in the following tables but can be
configured by using VisualSetup configuration program or referring to
NOTE
the related section in chapter 4 of this manual.
150
Sequence Format for Gun Configuration
$-
Character sequence in following tables
Interleaved 2/5: no check digit,
variable length code from 14 to 255 characters
Beeper tone 1
CR
Carriage return character (0D Hex.)
Exit and Save configuration
$- CR
Carriage return character (0D Hex.)
Exit and save new configuration
LYNX™ BT
Advertisement
Table of Contents
