Table of Contents
Advertisement
1
1.2
LYNX™ BT BATTERIES
To begin using your Lynx™ BT you must charge its Li-Ion batteries using the OM-1000
cradle or the C-1000 battery charger as described in the following paragraph.
Battery Charging
The first operation to perform is to connect the OM-1000 or the C-1000 to the power
converter and firmly insert the Lynx™ BT into the cradle to charge the batteries. The
red Charging LED will light. When the battery is completely discharged, a full charge
takes up to 4 hours. The Batt. Full LED will light when charging is completed. Press the
reader trigger to turn it on.
The LEDs positioned on the cradle or on the battery charger signal the charge status,
as described in the following table:
LED
Charging
Batt Full
The batteries must be charged at a temperature ranging from 0° to
45 °C (+32° to +113 °F).
NOTE
2
Figure 1 – OM-1000 BT Charging Batteries
Red On = the battery charge is in progress
Green On = the battery is completely charged
STATUS
LYNX™ BT
Power Cable
Advertisement
Table of Contents
