Use a Conditional Access
Module
A Conditional Access Module (CAM) is
provided by digital TV service operators to
decode digital TV channels.
Note
•
Refer to the documentation from your service
operator on how to insert a smart card into
the Conditional Access Module.
Insert and activate a CAM
Caution
•
Be sure to follow the instructions described
below. Wrong insertion of a CAM may
damage both the CAM and your TV.
1
Switch off the TV and disconnect it from
the power outlet.
2
Following the directions printed on the
CAM, gently insert the CAM into the
COMMON INTERFACE at the side of
the TV.
3
Push the CAM in as far as it will go.
4
Reconnect the TV to the power outlet.
5
Turn on the TV and wait for the CAM
to be activated. This may take several
minutes. Do not remove the CAM from
the slot when in use — removing the
CAM will deactivate digital services.
34
EN
Access CAM services
1
After inserting and activating the CAM,
press
MENU.
2
Press
to select [Setup] >
[Features] > [Common interface].
»
Applications provided by the digital TV
service operator appear on the screen.
Note
•
This menu option is available only if the CAM
is inserted and activated correctly.
Use Philips EasyLink
Your TV supports Philips EasyLink, which
uses the HDMI CEC (Consumer Electronics
Control) protocol. EasyLink-compliant devices
that are connected through HDMI connectors
can be controlled by a single remote control.
Note
•
The EasyLink-compliant device must be
switched on and selected as the source.
•
Philips does not guarantee 100%
interoperability with all HDMI CEC devices.