Cleanshot - WERTHEIM SE 9500 User Manual

Flow Gauge
Flow Gauge
InStructIonS For uSE

CleanShot™

CleanShot™
Before You Begin cleaning (cont'd)
Dry Aire™
Dry Aire™
2-In-1 WAtEr tAnK
Our 2-in-1 water tank full capacity system is designed
Flow Gauge
Flow Gauge
with a heavy duty bladder inside for clean water. As
you clean, the clean water in the bladder will empty
CleanShot
CleanShot ™
and mix with the cleaning formula. Dirty water pulled
™
out of your carpets will collect around the outside of
the bladder so that clean and dirty water are always
kept separate. This allows the user to maximize tank
Dry Aire
Dry Aire ™
™
space, yet only carry one tank to and from the sink
for emptying and filling.
EASY to rEmoVE And clEAn nozzlE
Cleaning up your machine after the cleaning
process is easy. Simply remove the 2-in-1 water tank
and remove the screw to pop out the nozzle for
rinsing in the sink.
Dirt, loose carpet fibres and remaining pet hair or fuzz
get washed away easily.
rEAdYtoolS™ dIAl
This provides either floor cleaning or above floor cleaning with the turn of a knob.
If choosing above floor cleaning for upholstery, stairs, or for those creases close to
the baseboards, turn knob to "TOOLS" and choose the attachment appropriate
for the job. Attach tool to the flex hose and you are ready to go. Be sure to turn
knob back to "FLOOR CLEANING" when done.
8
(cont'd)
Before You Begin cleaning
IMPORTANT: Do not use the carpet shampooer as a dry vacuum.
note: Vacuum carpet thoroughly. Use a vacuum cleaner with a
powerbrush for best results.
note: Remove as much furniture from the room as possible. If unable to
remove the furniture, place plastic or foil under and around the legs until
the carpet has dried completely.
1. Plan activities to give your carpet time to dry.
2. Move furniture to another area if cleaning an entire room (optional).
3. Vacuum area with a dry vacuum cleaner thoroughly before
deep cleaning.
4. Plan your cleaning route to leave an exit path. It is best to begin
cleaning in the corner farthest from your exit
5. Pretreating (optional).
Pretreating is recommended to improve cleaning effectiveness
for heavily soiled carpet in high traffic areas such as entry ways
and hallways.
clEAnShot™
A. Set Custom Clean for the desired setting.
B. Press the CleanShot button and aim the focused stream onto the
stain. Allow the formula to soak in for 30 seconds.
C. Run the machine over the stain to extract. Repeat as needed until the
stain is gone.
D. Rinse if desired.
9