Small Belt Removal & Replacement; Brush Removal & Large Belt Replacement - WERTHEIM SE 9500 User Manual

mAIntEnAncE
(cont'd)
Small Belt removal & replacement
Occasional replacement of one or both belts may become necessary.
If that is needed, please follow the instructions below.
1. Turn off the machine, and unplug it from the outlet.
2. Remove both the 2-in-1 water tank and the formula tank. Set aside.
3. Unscrew the front nozzle and remove it. Set aside.
4. Turn the machine on its side.
ImPortAnt: make sure that the cord side is down.
2 3
2
6 7
20
4 5
8 9
Small Belt removal & replacement (cont'd)
5. Remove the clear end cap by unscrewing the two black screws.
Take care not to drop the screws into the unit.
6. Remove one silver screw.
7. Remove pivot arm by gently lifting up.
8. Remove small brush belt.
9. Replace small brush belt, and reverse steps above.
Brush removal & large Belt replacement
note: Brushes can be removed for cleaning or replacement as needed.
1. Follow small belt removal Instructions on pages 20 & 21.
2. Remove brush rolls by pulling them off of the metal rods.
3. Place cleaned or new brush rolls back onto the rods. Make sure one
washer is on each end of the rollers prior to sliding onto the rod.
Be sure to let the rod slide through the bushing to insure proper fit.
4. Re-attach the long belt on the bottom to the cogs of the
small roller brushes.
2 3 4
21