Table of Contents
Advertisement
mAIntEnAncE
WArnInG: AlWAYS unPluG PoWEr cord From ElEctrIcAl
outlEt BEForE PErFormInG AnY SErVIcE on ExtrActor.
machine Storage
Once your cleaning is complete, make sure the 2-in-1 water tank is emptied,
rinsed out, and dried before the next use. The formula tank can remain filled
and ready to go, or it can simply be emptied back into the formula bottle if
that is more convenient.
note: Store cleaner in a protected, dry area. Since this product uses water,
it must not be stored where there is a danger of freezing. Freezing will
damage internal components and void the warranty.
machine care
For best results, a few simple steps can assure your machine is well
maintained after your cleaning is complete.
1.
Turn power and heater switches off. Unplug the machine and wrap the
power cord.
2.
After emptying the 2-in-1 water tank, rinse it out at a faucet with running
hot tap water, taking care to clean underneath the heavy duty bladder,
and all around it.
3. The top half of the tank can be rinsed clean
through the nozzle area. Also, pop out the red
filter underneath the top half of the tank and
rinse that out. Replace before putting the top
and bottom halves of the tank together.
18
machine care (cont'd)
4.
Before you place the cleaned 2-in-1 water tank back onto the
machine, simply unscrew the floor nozzle using a Phillips head
screwdriver. This can be rinsed out at the faucet. Then replace back
onto the machine by starting from the bottom of the nozzle and
hooking the tabs into the holes on the bottom sides of the machine.
Secure into place with the screw.
5.
The inside of the end caps by the brush rolls can be wiped out with
a clean paper towel, or, if a more thorough cleaning is desired, the
end caps can be taken off using a Phillips head screwdriver and
rinsed clean. Replace after cleaning.
6.
Any loose hair or debris can be pulled from the brush rolls and
thrown away. For the most thorough clean before storage, follow
directions on pages 20-22 for removal and replacement of the brush
rolls and belts.
7.
To clean attachments that may have been used, remove from hose
and rinse in clean, running water. Dry and replace attachment in
the tool caddy. Clean the hose by suctioning clean water from the
tap. Before replacing, lift end of hose and stretch out to ensure all
water is cleared from hose. Refer to page 16, instructions 9 & 10.
8.
After carpet is dry, vacuum again to remove hair and fuzz.
19
Hide quick links:
Advertisement
Table of Contents
