Stain Removal - WERTHEIM SE 9500 User Manual

InStructIonS For uSE
Important! If using to clean upholstery, check upholstery tags.
1 A. Check manufacturer's tag before cleaning. "W" or "WS" on the tag
means you can use your SE9500. If the tag is coded with an "X" or an
"S" (with a diagonal stripe through it), or says "Dry Clean Only", do not
proceed with any deep cleaning machine. Do not use on velvet or
silk. If manufacturer's tag is missing or not coded, check with your
furniture dealer.
B. Check for colour-fastness in an inconspicuous place.
C. If possible, check upholstery stuffing. Coloured stuffing may bleed
through fabric when wet.
D Plan activities to allow upholstery time to dry.
E. Vacuum thoroughly to pick up loose debris and pet hair. Use a vacuum
with a brush attachment and a crevice tool to clean in fabric folds.
2. Follow the instructions on pages 8 for filling the 2-in-1 water tank and the
formula tank.
3. Set ReadyTools dial to the hose attachments setting. This will allow spray
and suction from the hose.
4. Set Custom Clean dial for heavy traffic, normal clean, light clean,
or water rinse as desired.
5. Attach the cleaning tool to the end of the hose
6. Plug in and turn on the power switch and heater (if desired).
7. Clean by pressing the spray trigger to spray solution onto the area
to be cleaned. Slowly move the tool back and forth over the soiled
surface. Release the spray trigger to suction soiled water. Continue to
clean in the area, working in small sections, until no more dirt can be
removed. Rinse (optional) and suction as needed.
8. Remove and rinse tools in clean, running water. Dry and replace
in the tool caddy.
9. It is recommended that you suction clean water from the tap to rinse
out the hose.
10. Before replacing lift end of hose and stretch out to ensure all water is
cleared from hose.
16
(cont'd)
11. Coil flex hose around the tool caddy.
12. Empty 2-in-1 water tank and rinse out, following the instructions on
page 18-19.
13. Return ReadyTools dial to floor setting.

Stain removal

WARNING! To reduce the risk of fire and electric shock due
to internal component damage, use only BISSEll formula
intended for use with the deep cleaner. non-BISSEll
formulas may harm the machine and void the warranty.
Do Not Delay! Attending to an accident soon after it occurs ensures
the most optimal clean. Leaving it for an extended period of time may
cause it to set and become permanent.
1. Blot up liquids with an absorbent cloth or paper towels. White
materials are recommended because certain dyes may bleed and
make the stain worse.
2. Gently scrape up any semi-solids with a spoon or spatula. Do not use
a knife or other utensil with sharp edges because it could damage
the carpet or upholstery.
3. If the area has dried, remove the remaining semi-solids and residue
with a sweeper or vacuum.
4. Be sure to test any spot removal formulas in an inconspicuous
area first. This is important as some dyes and materials could be
damaged or discoloured by cleaning solvents. If such a change
should occur, try a different solution or call a professional.
5. If cleaning on Berber carpeting, gently run your machine over a
hidden area. If no fuzzing occurs, continue cleaning in soiled area.
6. CleanShot. CleanShot is an optional feature that can be used to
fight tough stains. It can be used as either a tough stain pre-cleaner
or can be used during the deep cleaning process itself. To use
CleanShot either as a pre-cleaner or during deep cleaning, follow
the instructions on page 9.
17