Advertisement
7.1) Assembling of the termination of the DBG-Y device with moving arm for clamping the drill
to the rail web and track fi ttings.
The termination TDB 6 of the DBG-Y device, with moving arm, have been designed for adaptation to
the diff erent operating conditions on the rails and track fi ttings; their assembly is shown in Fig. 13.
• When disassembling the TDB 6 termination ensure that, after removing the pivot, the complete
assembly is slid away downward without acting on the holding plate.
holding plate
FIG. 13 – ASSEMBLY OF THE TERMINATION
7.2) Assembly of the DBG-Y clamping device on the drill
The DBG-Y clamping device is fi tted to the front plate of the drill, centred by means of the refer-
ence pin supplied and secured with the two socket head cap screws M8x25 (35) also supplied. The
assembly is illustrated in Fig. 14.
17
Advertisement
