Epson SureColor P5000 User Manual page 166

LCD screen message Condition/solution
Paper Size Error The loaded paper is not a supported width. Press the
release the pressure roller, then remove the paper.
Load correct paper size.
If the message still appears when you have loaded paper in a supported
width, set the Paper Size Check setting to Off.
Paper Sensor Error The loaded paper is not detected correctly by the printer.
Loaded paper or print
Press the
out has a problem.
If this error appears while performing an automatic head alignment, check
the following:
• Make sure you that you have not loaded transparent or colored media,
• Make sure the printer is not exposed to direct, bright light (such as direct
• Run a nozzle check and make sure the print head nozzles are not clogged.
If this error appears at any other time, make sure that the printer supports the
loaded media.
Paper Low The roll paper is low. Make sure you have a replacement roll handy.
Paper Source Error Press the OK button to clear the message. Remove the cut sheets from the
printer and change the source in the Paper Type menu.
Cut sheet is loaded.
Remove it and change
paper source to roll
paper.
Paper Source Error Press the OK button to clear the message. Remove the roll paper from the
printer and change the source in the Paper Type menu. When Auto Roll
Roll paper is loaded.
Feeding is set to Off, you cannot change the paper type when roll paper is
Remove it and change
fed through the printer.
paper source to cut
sheet.
Paper Setting Error The paper source setting in the printer driver and in the printer's Paper Type
menu setting do not match. Check the loaded paper and settings in the driver
Check the paper source
and printer menus.
in your driver settings or
reload paper correctly.
pause/cancel button.
tracing paper, plain paper, Epson Enhanced Matte Posterboard, or paper
that is more than 0.04 inch (1 mm) thick.
sunlight) while performing an automatic print head alignment.
166
load paper button to