ATTO Technology FibreBridge 6500N Installation And Operation Manual page 22

SASQSFPInfo
Reports information about the SAS QSFP.
|
get SASQSFPinfo [a b | all]
SASTargets
Lists the physical devices that are connected to all SAS
connectors and PHYs.
SASTargets
SaveConfiguration
Many commands require a SaveConfiguration command to
be executed as indicated by the return Ready. *. When you
invoke a SaveConfiguration command, the current
configuration is permanently saved in the FibreBridge and the
new configuration becomes the active configuration. If a
firmware restart is required to make the requested change
permanent, you are asked to confirm the restart. You can
override this request by indicating the override value on the
command line. You may make several changes through
commands before implementing the restart, but once you have
restarted the FibreBridge, all the command changes created
before the restart and save are implemented. If you select the
restart option, the FibreBridge executes its complete start up
cycle.
SaveConfiguration <Restart | NoRestart>
SerialNumber
Reports the FibreBridge serial number. The serial number,
unique for each FibreBridge, is a 13-character field. The first
seven alphanumeric characters are an abbreviation of the
product name while the remaining six numbers are the
individual FibreBridge board's number.
get SerialNumber
SerialPortBaudRate
Configures/reports the baud rate for the FibreBridge RS-232
serial port or header. The number of data bits per character is
fixed at 8 with no parity.
Default: 115200
set SerialPortBaudRate [ 9600 |19200 | 38400 | 57600 |
115200]
Requires a SaveConfiguration Restart command
get SerialPortBaudRate
SNTP
Controls whether the FibreBridge contacts a specified SNTP
time server to initialize or synchronize the time.
Default: enabled
set SNTP [enabled | disabled]
Requires a SaveConfiguration Restart command
get SNTP
vii
ATTO Technology Inc. FibreBridge Installation and Operation Manual
SNTPServer
Controls/displays the main IP address of the SNTP time server.
If the FibreBridge is unable to contact the specified SNTP time
server within 30 seconds, the FibreBridge tries to contact the
first auxiliary SNTP time server. If not successful, the
FibreBridge tries to contact the second auxiliary server. If not
successful, the FibreBridge continues to keep time based on the
most recent SNTP time server, physical RTC or manual
initialization or synchronization.
Default: 192.43.244.18
set SNTPServer xxx.xxx.xxx.xxx
Requires a SaveConfiguration Restart command
get SNTPServer
Temperature
Displays the current internal temperature of the FibreBridge in
degrees Celsius.
get Temperature
Time
Controls/displays the time in a 24-hour format. The default time
is 00:00:00 and is accurate until the FibreBridge is reset or
power-cycled when it returns to the default.Time cannot be set
if SNTP is enabled.
Default: 0:00:00
set Time [HH :MM :SS]
Requires a SaveConfiguration command
get Time
TimeZone
Controls/displays the time zone. Setting may be EST, CST,
MST PST or a numerical offset from GMT in the format +/-
HH:MM. When SNTP is enabled, applies the time zone setting
to the time retrieved from a specified SNTP time server to
determine local time.
Default: EST
set TimeZone [EST | CST | MST | PST | [+ / - HH : MM]]
Requires a SaveConfiguration command
get TimeZone
Username
Specifies user name for all Telnet, FTP and ExpressNAV user
management console sessions. Username is case
insensitive, 1-32 characters, no spaces.
Default: root
set Username
Requires a SaveConfiguration command
get Username