Table of Contents
Advertisement
IPAddress
Controls/displays the current FibreBridge IP address.If
IPDHCP
is enabled, get command reports current IP address
assigned by the DHCP server.
Default: mp1= 10.0.0.1, mp2= 10.0.0.2
set IPAddress [mp1 | mp2] [xxx.xxx.xxx.xxx]
Requires a SaveConfiguration Restart command
get IPAddress[mp1 | mp2]
IPDHCP
Selecting DHCP allows the FibreBridge to request an IP
address from the network. The network must have at least one
DHCP server.
Default: enabled
set IPDHCP [mp1 | mp2] [enabled | disabled]
Requires a SaveConfiguration Restart command
get IPDHCP [mp1 | mp2]
IPDNSServer
Controls the current DNS Server address. If
enabled, the DNS Server address is automatically detected. If
IPDHCP is disabled, you must set the address manually using
this command.
set IPDNSServer [xxx.xxx.xxx.xxx]
get IPDNSServer
IPGateway
Regulates/displays the current gateway. If
get command reports current IP gateway assigned by a DHCP
server.
Default: mp1= 0.0.0.0, mp2= 0.0.0.0
set IPGateway [mp1 | mp2] xxx.xxx.xxx.xxx
Requires a SaveConfiguration Restart command
get IPGateway [mp1 | mp2]
IPSubnetMask
Regulates/displays the current subnet mask. If
enabled, get command reports current subnet mask assigned
by DHCP server.
Default: 255.255.0.0
set IPSubnetMask [mp1 | mp2] xxx.xxx.xxx.xxx
Requires a SaveConfiguration Restart command
get IPSubnetMask [mp1 | mp2]
Password
Specifies password for all non-serial sessions: Telnet, FTP and
ExpressNAV interface. You are prompted for the current
password, to enter the new password, and to confirm the new
password. When the password is all 0s, Telnet and FTP do not
validate the password and MD5 authentication is
disabled.Configure an empty password by pressing the Enter
key when prompted for the new password and the new
password confirmation.Passwords are case sensitive and can
be 1-32 characters long with no spaces.
Default: Password
set Password
Requires a SaveConfiguration command
Ping
Sends an ICMP echo request to the specified host.
Ping [mp1 | mp2] [xxx.xxx.xxx.xxx] <count <size>>
ReadOnlyPassword
Specifies read only password for all non-serial sessions: Telnet,
IPDHCP
is
FTP and ExpressNAV interface. ReadOnlyPassword is case
sensitive, 0 to 32 characters, and cannot contain spaces.
Default: Password
set ReadOnlyPassword
Requires a SaveConfiguration command
ReadOnlyUsername
Specifies read only user name for Telnet and ExpressNAV user
IPDHCP
is enabled,
management console sessions. Username is case
insensitive, 1-32 characters, no spaces.
Default: User
set ReadOnlyUsername
Requires a SaveConfiguration command
get ReadOnlyUsername
Reset FCPortErrors
Resets all FC error counts for the specified port to zero. Refer to
IPDHCP
is
FCPortErrors
ResetFCPortErrors [fp | all]
RouteDisplay
Displays a list of Fibre Channel to target device address
mappings on the FibreBridge.
RouteDisplay FC
SASPortList
Lists the status of both SAS ports. Only the 'A' labelled
connector may be used to connect disk shelves.
SASPortList
command.
vi
Advertisement
Table of Contents
