Table of Contents
Advertisement
Command
ReadOnlyPassword
ReadOnlyUsername
ResetFCPortErrors
RouteDisplay
SASPortList
SASQSFPInfo
SASTargets
SaveConfiguration
SerialNumber
SerialPortBaudRate
SNTP
SNTPServer
Temperature
Time
TimeZone
Username
zModem
Command explanations
BridgeModel
Reports model and firmware information about the FibreBridge.
get BridgeModel
BridgeName
Specifies the eight-character ASCII name assigned to the
FibreBridge used to identify individual units. It is not the World
Wide Name. The string is alphanumeric, eight characters long,.
Changes take effect immediately.
Default: " "
set BridgeName [name]
get BridgeName
ClearEventLog
Clears the contents of the event log. No new entries are
recorded until the operation is completed.
ClearEventLog
Default
Example
Password
get readonlypassword
user
get readonlyusername
resetfcporterrors 1
routedisplay fc 1 1
sasportlist
get sasqsfpinfo a
sastargets
saveconfiguration restart
get serialnumber
115200
set serialportbaudrate 19200
enabled
get sntp
192.43.244.18 set sntpserver 129.6.15.28
get temperature
00:00:00
set time 03:32:30
EST
set timezone pst
root
set username Barbara
zmodem receive
Date
Sets/displays the date. The range is 01/01/2000 to 12/31/2099.
Default: 01/01/2000
set Date [MM] / [DD] / [YYYY]
Requires a SaveConfiguration command
get Date
DumpConfiguration
Displays the FibreBridge configuration.
DumpConfiguration
DumpEventLog
Dumps portions of the event log to the ExpressNAV Advanced
page text box, RS-232 or Telnet session. Without parameters
the command will return the newest 2,048 entries. Use caution
when entering "all" or a very large number, since it may take
several minutes to complete
DumpEventLog <all | 1-40,000>
iv
Advertisement
Table of Contents
