Table of Contents
Advertisement
EthernetPort
Sets/displays the active ethernet management port(s)
Default: mpl enabled, mp2 disabled
set EthernetPort [mp1 | mp2] [enabled | disabled]
get EthernetPort [mp1 | mp2]
EthernetSpeed
EthernetSpeed determines the speed of any Ethernet port(s). If
Auto is enabled then the Ethernet speed will be negotiated and
the value in parentheses returned by the 'get' command
indicates the current speed of the Ethernet connection. When
hard set, 100 speed is half duplex.
Default: auto
set EthernetSpeed [mp1 | mp2] [ 100 | 1000 | Auto ]
Requires a SaveConfiguration Restart command
get EthernetSpeed [mp1 | mp2]
If auto enabled, returned value in parentheses indicates
current speed
Exit
Ends the current Ethernet Telnet CLI session; it has no effect if
used during a serial CLI session.
Exit
FCConnMode
Controls/reports the connection the FibreBridge uses when
communication across a FC network, either to an arbitrated loop
(FC-AL) when you select loop, or point-to-point when you
choose ptp. If you choose loop-ptp or ptp-loop, the
FibreBridge tries to use the first parameter first, but uses the
second if it cannot use the first.
Default: loop-ptp
set FCConnMode [fp | all] [loop | ptp | loop-ptp | ptp-loop]
Requires a SaveConfiguration Restart command
get FCConnMode [fp | all]
FCDataRate
Specifies the rate the FibreBridge uses, 2 Gb/sec. 4 Gb/sec. 8
Gb/sec. or auto negotiate.
Default: auto
set FCDataRate [fp | all] [2Gb | 4Gb | 8Gb |auto]
Requires a SaveConfiguration Restart command
get FCDataRate [fp | all]
FCPortErrors
Displays the number of Fibre Channel errors that have occurred
since the last reboot/power-on or
command.
get FCPortErrors [fp | all]
v
ATTO Technology Inc. FibreBridge Installation and Operation Manual
Reset FCPortErrors
FCPortList
Returns a list of available FC ports and their current status. Valid
status values are Up, Down, Failed, Reserved and
Disabled.
FCPortList
FCSFPInfo
Reports information about the FC SFP+.
get FCSFPInfo [fp | all]
FCWWName
Reports the Word Wide Name (WWN) of the FC interface. Each
FC port has an individual and unique WWN.
get FCWWN [fp | all]
FirmwareRestart
Causes the FibreBridge to reboot, then re-initialize its
firmware.Use the forced option to override any CLI reservation
held by other sessions.
FirmwareRestart <forced>
FlashImages
Displays information for the two software images stored in the
flash. 'validate' validates the CRC of each image (this takes
several seconds).
FlashImages <validate>
Help
Displays a list of available commands. If command name is
specified, displays detailed command-specific information.
Help [command name]
IdentifyBridge
Enabling this causes the Alert LED on the FibreBridge to blink
until the parameter is disabled.
Default: disabled
set IdentifyBridge [enabled | disabled]
get IdentifyBridge
Info
Displays version numbers and other production information for
key components within the FibreBridge. Use the "brief"
parameter to show a subset of information.
Info <brief>
Advertisement
Table of Contents
