Wall Mounted (K1 Type) - Panasonic S-22MU1E5A Technical Data Manual

2. SELECTING THE INSTALLATION SITE

2-6. Wall Mounted (K1 type)

AVOID:
areas where leakage of flammable gas may be expected.
places where large amounts of oil mist exist.
direct sunlight.
locations near heat sources which may affect the
performance of the unit.
locations where external air may enter the room directly.
This may cause "condensation" on the air discharge ports,
causing them to spray or drip water.
locations where the remote controller will be splashed with
water or affected by dampness or humidity.
installing the remote controller behind curtains or furniture.
locations where high-frequency emissions are generated.
1
DO:
select an appropriate position from which every corner of the
room can be uniformly cooled.
select a location where the ceiling is strong enough to
support the weight of the unit.
2
WARNING
select a location which can support a load that is four times the indoor unit weight.
select a location where tubing and drain pipe have the shortest run to the outdoor unit.
allow room for operation and maintenance as well as unrestricted air flow around the unit.
3
install the unit within the maximum elevation difference above or below the outdoor unit and within a total tubing length (L)
from the outdoor unit as detailed in the Installation Instructions provided with the outdoor unit.
allow room for mounting the remote controller about 1 m off the floor, in an area that is not in direct sunlight or in the flow
of cool air from the indoor unit.
4
NOT E
Air delivery will be degraded if the distance from the floor to the ceiling is greater than 3 m.
5
6
7
8
9
The air inlet and outlet of the indoor unit must be free of
any obstructions to allow air to spread throughout the room.
1. The indoor unit must be within a maintenance soace.
min.
5 cm
2-14
Design of VRF SYSTEM
min. 7.5 cm
min.
5 cm
Front View
Fig. 2-17