Hotpoint RB787 Use And Care Manual page 30

A
WARNING
All ranges can tip.
Injury could result.
. Install the Anti-tip device
packed with the range.
. See the Installation
Instructions.
STABILITY DEVICE INSTALLATION INSTRUCTIONS FOR BRACKET KIT NO. 342473
Phil I ips head screwdriver
I ~~" open end or adjustable wrench
The
right or left rear leg leveler. If fastening to the floor,
be sure that the screws do not penetrate electrical
wiring or plumbing. If this cannot be determined, use
shorter screws that will not penetrate through
attached to the lower range bock. Remove and discard
the shipping screw that holds the bracket and then
1. Decide whether the bracket will be instatled on the
cabinet, p]tice the bracket against back watl ~ind
cabinet as shown in Figure 1.
the location of the range side (painted outside
.
or final ' \
range
Make sure Z
30
Outside edge of
bracket to be flush
with left or right side
of range
Wall behind range
3. Determine whether
the floor or wail. Fasten the bracket securely with
the screws provided. The screws are self-drilling in
wood. plywood, particle and chip boord. and most
metal framing. If atttiching to masonry you can buy
a masonry dri II to drill the required holes.
4. Using the wrench, back out the
5. Slide the range into place. Be sure the rear leg
leveler fully engages the slot in the bracket, It
the rear leg leveter to enter the bracket, move the
bracket forward os l"equired and attach to the hoot
in the new location,
Screw must enter wood
or metal
Attachment to wall
will anchor the brucket to
Wall Plate