Page 1
Description 10.8V Cordless Angle Drill 10mm (3/8") DA330D ONCEPT AND MAIN APPLICATIONS Models DA330D/ DA331D have been developed as the first 10.8V Li-ion cordless angle drills. The compact angle head and its small center height allow easy access to DA331D tight spaces where DC driver drills cannot do it.
Retaining Ring S-12 1R398 Bearing retainer wrench loosening / fastening Bearing retainer [2] LUBRICATION Apply Makita grease N No.2 to the following portions designated with the black triangle to protect parts and product from unusual abrasion. Item No. Description Portion to lubricate...
Page 3
P 3/ 10 epair [3] DISASSEMBLY/ASSEMBLY [3] -1A. Drill Chuck and Spiral bevel gear 31 for DA330D DISASSEMBLING Drill chuck is factory assembled to Spindle to which Spiral bevel gear 31 is mounted. Consequently, it is impossible to replace Drill chuck singly without removing Spiral bevel gear 31 from the Spindle portion of Drill chuck.
Page 4
P 4/ 10 epair [3] DISASSEMBLY/ASSEMBLY [3] -1A. Drill Chuck and Spiral bevel gear 31 for DA330D (cont.) ASSEMBLING Assemble Drill chuck section by reversing the disassembly procedure. (Refer to the illustrations in Fig. 2A) Note in Assembling 1: Close the three Jaws for easy assembling Ball bearing 6806DDW.
Page 5
P 5/ 10 epair [3] DISASSEMBLY/ASSEMBLY [3] -2. Spiral bevel gear 31 for DA331D (cont.) DISASSEMBLING (3) Disassemble Gear section as drawn in Fig. 4. Fig. 4 2. Disassemble the gear section 3. Bearing box can be removed by hand. Remove Ball bearing 608ZZ by tapping the edge of Gear with 1R269, and remove Retaining ring S-12 with 1R291.
Page 6
P 6/ 10 epair [3] DISASSEMBLY/ASSEMBLY [3] -3A. Spiral bevel gear 6 and Spur gear 42 for DA330D DISASSEMBLING (1) Take out Spiral bevel gear 6 and Spur gear 42 as drawn in Fig. 5. Fig. 5 1. Remove Key holder from 2.
Page 7
[3] -3B Spiral bevel gear 6 and Spur gear 42 for DA331D DISASSEMBLING (1) Take out Gear housing in the same way as DA330D. (See Fig. 5) (2) Disassemble Spiral bevel gear 6 and Spur gear 42 as drawn in Fig. 8.
Page 8
P 8/ 10 epair [3] DISASSEMBLY/ASSEMBLY [3] -3B Spiral bevel gear 6 and Spur gear 42 for DA331D ASSEMBLING (1) Assemble Spiral bevel gear 6 to Spur gear 42 as drawn in Fig. 9. Fig. 9 Spiral bevel gear 6 Ball bearing 608ZZ Lock ring Pin 3.5...
P 9/ 10 ircuit diagram Fig. D-1 Color index of lead wires' sheath Black White Note: Circuit diagram of Switch and DC motor as drawn below is the view from Housing set (L) side. Terminal Switch DC Motor Connector LED Light circuit iring diagram Wiring to Electrical parts...
Page 10
P 10/ 10 iring diagram Wiring of Lead wires of LED Light circuit (before setting Switch) Fig. D-5 Put the slag portion of Lead wires to this place (about under Switch). Lead wire holder Connector Lead wire holder LED Light circuit Lead wire holder Lead wires have to be fixed with Lead wire holders.