Makita DA330D Technical Information page 10

W
iring diagram
Fig. D-5
Lead wire holder
Connector
Lead wire holder
Lead wires have to be fixed
with Lead wire holders.
Fig. D-6
Be careful not to put these Lead wires
on or over Rib A and Boss A.
Rib A
Boss A
Rib B
Terminal
Put Lead wire (red) between Rib B
and Switch.
Be careful not to put this wire (red)
on or over Rib B.
Wiring of Lead wires of LED Light circuit
(before setting Switch)
Lead wire holder
Set LED Light circuit to
Housing set (L) while
facing Circuit plate to
DC motor side.
Wiring in Housing set (L)
(After setting Switch and DC Motor)
Boss B
Switch
Rib D
Put the slag portion of Lead wires
to this place (about under Switch).
Circuit plate
DC motor
side
Inflect (+) Terminal of DC motor so that
the terminal can be located between
Boss B and Rib C.
Red mark
DC Motor
Rib C
Inflect (-) Terminal of DC motor so that
the terminal can be located between
Rib C and Rib D.
Put the slag of Lead wire (red) between
Rib C and Switch as drawn above.
P 10/ 10
LED Light circuit
Projection
of Adhesive