Clarke-tech C-Tech HD 6600 SST Manual page 9

6.1 Getting Started
4) Antenna Setup
Press the MENU button to display the main menu.
Use / and / to move in the menu.
Press on 'Dish Setting'. The following window will appear. <Figure 6.1.6>
If you have a motorized dish, press
Note : Enter a 4-Digit password if need arise. The default password is '0000'.
<Figure 6.1.6>
Select the item that you want to edit, and set its parameters as desired. <Dish Setting>
- Satellite : Select any satellite by pressing
- Tuner : Select Tuner1 / Tuner2 / Both(Tuner1) / Both(Tuner2).
- Frequency : Select the Frequency
- LNB Power : Select among ON/OFF/13V/18V.
- LNB Type : Select among Single/Universal/OCS.
- LNB Freq : Set the frequency of the LNB oscillator.
- 22KHz : When not AUTO, set the signal path from LNB or switch by selecting a control
signal among 0/22KHz.
- DiSEqC 1.0 : Select DiSEqC 1.0 Port.
- DiSEqC 1.1 : Select DiSEqC 1.1 Port.
Select the item that you want to edit and set its parameters as desired. <Motorized
Setting>
- Satellite : Select any satellite by pressing
- Tuner : Select Both(Tuner1) / Both(Tuner2).
- Frequency : If the default TP frequency is not appropriate, you can select another TP
frequency at which to check for signal.
- DiSEqC Motor : Select DiSEqC protocol among OFF/1.2/USALS as appropriate for your
Motor.
on 'Motorized Setting'. < Figure 6.1.7>
<Figure 6.1.7>
/ buttons on the remote.
/ buttons on the remote.
16
6.1 Getting Started
( When the DiSEqC Motor parameter is set as 1.2 )
- Move : You can move the dish to the West/East.
- Move Fine : Move the dish position 1 step at a time to west/east by pressing
buttons.
- Limit : If you want to set limits, press
Disable Limit : You can disable the East and West limits.
Goto Center : Move the dish to the initial 0 position.
Set East / West Limit : Move the dish East or West using
- Go To : Go to the position of the saved satellite.
- Save / Recalculate
Save : Save the current setting of DiSEqC 1.2 system.
Recalculate : Recalculate the position of all other saved satellites relative to the known position.
( When the DiSEqC Motor parameter is set as USALS )
- Move : Move the dish position to West/East by pressing
- Limit : If you want to set limits, press
Disable Limit : You can disable the East and West limits.
Goto Center : Move the dish to the initial 0 position.
Set East / West Limit : Move the dish East or West using
- Sat Degree : Displays the current degree of the selected satellite. Edit degree by
pressing / buttons and numeric buttons.
- Antenna Position : Press .
Goto Reference : Move the dish to the reference 0 position.
Antenna Longitude : Edit antenna longitude by pressing
Antenna Latitude : Edit antenna latitude by pressing
- Go To : Save the current setting of USALS System.
Note : You need to know what LNB you are using to correctly set the L.O. (local
oscillator) frequency.
Note : You need to understand how your receiver is connected to properly set the
22KHz and DiSEqC.
When you are done, press the EXIT button.
/
.
/ .
Press to set East or West limit
/ buttons.
.
/ .
Press to set East or West limit
/
buttons and numeric buttons.
/
buttons and numeric buttons.
17