Panasonic BL-WV10A Setup Manual page 6

Quick Setup
To use the BL-WV10A with your cameras, you will need to configure the BL-WV10A and your cameras. The
BL-WV10A's Quick Setup utility can help you configure the devices easily.
1. After the unit restarts, wait while the Quick Setup utility scans for network and wireless settings.
• When the BL-WV10A has been configured, "Finished" is displayed and the buzzer sounds.
• With this connection setup, it is normal for no router or wireless router to be found.
2. Wait while the Quick Setup utility restarts the camera, then configures and registers the camera.
• When the camera has been configured and registered, "Finished" is displayed next to the camera
name ("CAM1") and the buzzer sounds.
3. To register another camera, connect the camera to one of the LAN jacks of the BL-WV10A, then turn the
camera on by connecting it to the power outlet.
To finish, set the BL-WV10A's mode switch to [NORMAL], disconnect the DC cord from the rear of the
unit, reconnect the DC cord, then continue from "Viewing Camera Images" on page xx.
→
Setup Guide
6