Fcc And Other Information - Panasonic BL-WV10A Setup Manual

Wireless camera monitoring system
Hide thumbs Also See for BL-WV10A:
Table of Contents

Advertisement

Setup Guide

FCC and Other Information

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
• Consult the dealer or an experienced radio/TV technician for help.
This product operates at frequencies that may cause interference to nearby TVs and VCRs. To minimize or
prevent such interference, the base of this product should not be placed near or on top of a TV or VCR. If
interference is experienced, move this product further away from the TV or VCR. This will often reduce or
eliminate interference. Operating near 2.4 GHz electrical appliances may cause interference. Move away from
the electrical appliances.
Environment
Do not place the product in a room where the temperature is less than 0 °C (+32 °F) or greater than +40 °C
(104 °F). Allow 10 cm (4 inches) clearance around the product for proper ventilation.
Avoid excessive smoke, dust, mechanical vibration, shock, or direct sunlight.
Routine care
Wipe the product with a soft cloth. Do not use benzine, thinner, or any abrasive powder. When you leave the
product unused for a long period of time, unplug the AC cord plug from the outlet.
If there is any trouble
Consult an authorized Panasonic Factory Service Center.
FCC RF Exposure Warning:
• To comply with FCC RF exposure requirements in uncontrolled environment:
• This equipment must be installed and operated in accordance with provided instructions and a
minimum 20 cm (8 inches) spacing must be provided between antenna and all person's body
(excluding extremities of hands, wrist and feet) during wireless modes of operation.
• This transmitter must not be co-located or operated in conjunction with any other antenna or
transmitter.
13

Advertisement

Table of Contents
loading

Table of Contents