4. Troubleshooting
4-1 Failure Display Codes
Safety error
"E-08" or
"E-0A" or
"E-0E"
Disconnect power and sub PCB
* DLB, Bake, Broil,convection relay
check.(Nomal:
)
* Check whether there is any damaged
parts of sub PCB pattern.
Ok
* Measure oven sensor resistance.
(1080 at the room temperature)
* Check the connecting condition of
harness related with oven sensor.
Ok
* Check connector and harness connected to Sub PCB.
* Check whether harness on connector
(CN04, CN05) of main PCB is connected nomally
into the connector(CN04, CN05) or not.
Ok
With replacing sub PCB or main PCB, and make set work.
END
* Replace Sub PCB
No
* Solder again if pattern is damaged
or parts is wrong contacted.
END
No
*Reconnect after replacing the oven
sensor.
END
No
CN04
No
Replace or repair the harness.
Replace sub PCB or main PCB
34
CN05