Table of Contents
Advertisement
Saniclave RS-SC-200
17. Dry Mode: After the chamber drains, the autoclave will sound an audible
alarm that reads "turn door." Rotate door counter clockwise until it is in
the open position. Tuck the door under the retainer clips below the door
opening. Then press the ADVANCE button and the alarm will cease.
During this mode, the heater warms the chamber for 30 minutes. Moist air
vents out of the door gap.
18. Cycle Complete: "CC" will display if the cycle was successful.
19. Print Mode: If the Saniclave 200 is connected to a printer, a cycle report
will print when SET button is pressed, showing the date/time, preset and
achieved parameters.
Caution: internal chamber contents may be hot to the touch.
A Recommended Load Configuration
Load must not exceed 4.5 lbs. Stand packs upright if possible.
Cycle Phases
Fill
Preheat Mode.
Sterilization Mode
Dry Mode
CC Mode
Print
R E V O L U T I O N A R Y S C I E N C E
Display reads "Fill" if the 'START' button is
pressed and the chamber has not yet been filled
with sufficient water.
Display will read 'Ph' for Preheat. This mode will
usually last for about 30 minutes, depending on
the load size.
Display will show temperature in Celsius:
•
Press ADVANCE to view the pressure reading in
PSIg.
•
Press SET to view the cycle time remaining.
When the sterilization cycle is successfully completed, the
display will read 'dry,' for drain mode. As the water
drains, the chamber completely depressurizes and shortly
thereafter (if selected), the Dry Mode begins. Display will
alternate between "dry" and the 30 minute timer. When
the display reads "turn door," the door must be opened
by rotating the door counter clockwise to the open
position until the Dry Mode is complete.
After a successful completion of the entire cycle, the
display will read 'CC' for Cycle Complete. Remove the
door and remove the instruments. Instruments may be
warm to the touch.
Date/time, preset and achieved parameters are printed.
8
Advertisement
Table of Contents
