Failure Analysis; Technical Information; Specific Absorption Rate Data - Motorola FX1900P User Manual

Dual band wireless local loop phone
Table of Contents

Advertisement

11. FAILURE ANALYSIS

Symptoms
Possible Causes
Inadequate
battery
Power- on
power
Failure
Poor battery contact
Automatic
Seriously poor
battery power
power- off
Deceasing of battery
Inadequate
performance
standby
time
Poor network signal
Poor network signal
Network
connection
Out of the service
failure
area
Call drop
Poor network signal
during a
call
The terminal is set to
Silence,
or
the
No ring for
a incoming
volume for incoming
call
call ringtone is set to
0.
UIM card is locked
Prompt to
due
to
successive
input PUK
inputting false PIN
code for three times.
42
Solutions
Charge the battery
Re-install the battery
Recharge the battery
Replace the battery
Move to other places
Move to other places
Confirm whether it
is
in
the
CDMA
network service area
Move to other places
Enter [Settings] and
set the
mode
as
non-mute; or check
ringtone volume.
Contact
with
operators.

12. TECHNICAL INFORMATION

12.1 Specific Absorption Rate Data

This model meets international guidelines for exposure to radio waves.
Your mobile device is a radio transmitter and receiver. It is designed not to exceed
the limits for exposure to radio waves recommended by international guidelines.
These guidelines were developed by the independent scientific organization
ICNIRP and include safety margins designed to assure the protection of all persons,
regardless of age and health.
The guidelines use a unit of measurement known as the Specific Absorption Rate,
or SAR. The ICNIRP SAR limit for mobiles devices used by the general public is 2
W/kg and the highest SAR values for this device when tested, were Body: <value>
W/kg, Head: <value> W/kg.>*
As SAR is measured utilizing the device's highest transmitting power, the actual
SAR of this device while operating is typically below that indicated above. This is
due to automatic changes to the power level of the device to ensure it only uses the
minimum level required to reach the network.
While there may be differences between the SAR levels of various phones and at
various positions, they all meet the governmental requirements for safe exposure.
Please note that improvements to this product model could cause differences in the
SAR value for later products; in all cases, products are designed to be within the
guidelines.
The World Health Organization has stated that present scientific information does
not indicate the need for any special precautions for the use of mobile devices. They
note that if you want to reduce your exposure then you can do so by limiting the
43

Advertisement

Table of Contents
loading

Table of Contents