Hand/Arm Vibrations - Fein BOP6 Series Instruction Manual

OBJ_BUCH-0000000221-001.book Page 6 Tuesday, July 21, 2015 8:42 AM
en
6

Hand/arm vibrations.

While working with this power
WARNING
tool, hand/arm vibrations
occur. These can lead to health impairments.
The vibration emission value
WARNING
during actual use of the power
tool can differ from the declared value
depending on the ways in which the tool is
used.
It is necessary to identify safety
WARNING
measures to protect the oper-
ator that are based on an estimation of expo-
sure in the actual conditions of use.
The vibration emission level given in this
information sheet has been measured in
accordance with a standardised test given in
EN 60745 and may be used to compare one
tool with another. It may be used for a pre-
liminary assessment of exposure.
Emission values for sound and vibration (Two-figure – specifications as per ISO 4871)
Sound emission
A-weighted emission pressure power
level measured at the workplace
(re 20 μPa), in decibels
K
Measuring uncertainty
Measured A-weighted sound power
L
level (re 1 pW), in decibels
wA
K
Measuring uncertainty
C-weighted peak sound pressure level
measured at the workplace
decibels
K
Measuring uncertainty
bels
Vibrations
Weighted acceleration, in
2
– m/s
2
– ft/s
Measuring uncertainty K
2
– m/s
2
– ft/s
REMARK: The sum of the measured emission value and respective measuring inaccuracy
represents the upper limit of the values that can occur during measuring.
Wear hearing protection!
Measured values determined in accordance with the corresponding product standard.
The declared vibration emission level repre-
sents the main applications of the tool. How-
ever if the tool is used for different
applications, with different accessories or
poorly maintained, the vibration emission
may differ. This may significantly increase the
exposure level over the total working period.
An estimation of the level of exposure to
vibration should also take into account the
times when the tool is switched off or when
it is running but not actually doing the job.
This may significantly reduce the exposure
level over the total working period.
Identify additional safety measures to protect
the operator from the effects of vibration
such as: maintain the tool and the accessories,
keep the hands warm, organisation of work
patterns.
BOP6 (**) BOP10 (**) BOP10-2 (**) BOP13-2 (**)
L
pA
82
, in decibels
pA
93
, in decibels
wA
L
, in
pCpeak
96
, in deci-
pCpeak
13
, in
1.5
82
3 3
93
3 3
96
3 3
4 3
10
1.5
5 5
82 82
3 3
93 93
3 3
96 96
3 3
3 3
10 10
1.5 1.5
5 5