Charge The Phone - Vertu SIGNATURE S VM-06 User Manual

3. Insert the battery at a slight angle, so the metal contacts on the battery align with the metal
contacts on your phone.
4. Lower the bottom of the battery into the battery compartment until it slots into place.
5. To replace the battery cover, insert the bottom clip of the cover into the slot below the battery.
6. Gently push the top of the battery cover until it clicks into place.
7. Close the battery cover release D-ring.

Charge the phone

The battery needs activating prior to first use, and it is recommended to charge the battery at this point as it
may not have been supplied with a full charge. Connect the supplied USB data cable into the charging port
on the side of the phone. Then connect the other end of the cable to the USB port on your Vertu mains
charger.
!
Important: Use only chargers, cables and accessories supplied by Vertu.
© 2017 Vertu Corporation Limited. All rights reserved.
Getting started
11