Charge The Phone - Vertu Ti User Manual

Charge the phone

The internal battery needs activating prior to first use, and it is recommended to charge the battery at this
point as it may not have been supplied with a full charge. Connect the supplied USB data cable into the
charging port on the side of the phone. Then connect the other end of the cable to the USB port on your
Vertu mains charger.
!
Important: Use only chargers, cables and accessories supplied by Vertu.
If the phone indicates a low charge, do the following:
1. Connect the supplied wall charger to the wall outlet and then insert the micro-USB connector into
your phone.
2. When the battery is fully charged, disconnect the charger from the phone and then from the wall
outlet.
Note:
You can use the phone while it is charging.
l
If the battery is completely discharged, it may take several minutes before the charging indicator is
l
displayed or before you can make any calls.
Tip: You can also charge your VERTU Ti phone using the Vertu Portable Power pack or the vehicle
charger, supplied in the sales box.
Charge the battery using the Vertu Portable Power pack
To charge the Vertu Portable Power pack connect the USB data cable supplied into the charging port on
the base. Then connect the other end of the cable to the USB port on your Vertu mains charger.
Once the Vertu Portable Power pack is charged, you can connect it to your phone to charge the phone
while you are on the move.
© 2013 Vertu Corporation Limited. All rights reserved.
Getting started
13