Vertu SIGNATURE S VM-06 User Manual page 76

Operation is subject to the following two conditions: (i) the Product(s) may not cause harmful interference,
and (ii) the Product(s) must accept any interference received, including interference that may cause
undesired operation. Any changes or modifications not expressly approved by Vertu could void the user's
authority to operate this equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
Reorient or relocate the receiving antenna.
l
Increase the separation between the equipment and receiver.
l
Connect the equipment into an outlet on a circuit different from that to which the receiver is
l
connected.
Consult the dealer or an experienced radio/TV technician for help.
l
This Class B digital apparatus complies with Canada ICES-3(B)/NMB-3(B).
The device could automatically discontinue transmission in case of absence of information to transmit or of
operational failure. Note that this is not intended to prohibit the transmission of control or signalling
information or the use of repetitive codes where required by the technology.
ISED Canada Notice
RSS-Gen 8.4
This device complies with Innovation, Science and Economic Development Canada license-exempt RSS
standard(s). Operation is subject to the following two conditions:
1. This device may not cause interference, and;
2. This device must accept any interference, including interference that may cause undesired
operation of the device.
IC: 4299A-VM06
ISED Canada Radiation Exposure Statement
This EUT is compliance with SAR for general population/uncontrolled exposure limits in RSS-102 and had
been tested in accordance with the measurement methods and procedures specified in IEEE 1528 and
IEC 62209. This equipment should be installed and operated with minimum distance 1.0 cm between the
© 2017 Vertu Corporation Limited. All rights reserved.
Safety and warranty
76