Product Configuration; Unit Startup; Ip Address Viewing; Normal Startup Confirmation - Reach ENC110 User Manual

II. Product Configuration

2.1 Unit Startup

Check the power cable, and ensure that the power adaptor is properly and reliably
connected to the unit.
When the power adaptor is connected to the encoder, the PWR LED on the panel will
be on, indicating that the external power is connected, and the equipment has started
operation.

2.2 IP Address Viewing

The default IP address of the encoder is a random address. You can view the IP
address of the current encoder at the rolling information display field of the LCD panel.
(Note: For the convenience of illustration, assuming that the IP address of the
encoder is 192.168.1.100, and the subnet mask is 255.255.255.0.)
To ensure the normal network connection between your computer and the encoder,
change the IP address of your computer to the same network segment of the encoder,
e.g., 192.168.1.110, 255.255.255.0.

2.3 Normal Startup Confirmation

Before setting the IP address of the encoder, check if the encoder has been normally
started. Open the command line mode window with the system tool. For instance, in
the Windows system, click Start→run→command to open the command line window,
and enter <ping 192.168.1.100> in the command line window, and then click Enter
key. If the following message appears, it indicates that the encoder has been normally
started.
Copyright© Shenzhen Reach IT Co., Ltd.
REACH ENC110 SD Encoder
User Manual
7 / 12