Tools And Supplies Needed; Inspect Appliance And Components - Harman Allure50 Installation Manual

B. Tools And Supplies Needed
Tools and building supplies normally required for
installation, unless installing into an existing masonry
fireplace:
• Reciprocating Saw
• Hammer
• Phillips Screwdriver
• Tape Measure
• Level
• Non-Combustible Sealant
C. Inspect Appliance and Components
• Carefully remove the appliance and components from the
packaging.
• Report to your dealer any parts damaged in shipment,
particularly the condition of the glass.
• Read all of the instructions before starting the
installation. Follow these instructions carefully during
the installation to ensure maximum safety and benefit.
DO NOT:
• Install or operate damaged appliance.
• Modify appliance.
• Install other than as instructed by Hearth & Home
Technologies.
• Operate the appliance without fully assembling all
components.
• Overfire.
• Install any component not approved by Hearth &
Home Technologies.
• Install parts or components not Listed or approved.
• Disable safety switches.
Improper installation, adjustment, alteration, service or
maintenance can cause injury or property damage.
For assistance or additional information, consult a qualified
installer, service agency or your dealer.
!
RISK OF FIRE OR EXPLOSION!
DAMAGED PARTS COULD IMPAIR SAFE
OPERATION. DO NOT install damaged,
incomplete or substitute components.
Keep appliance dry.
6
• Gloves
• Safety Glasses
• Electric Drill & Bits
May also need:
• Vent Support Straps
• Venting Paint
WARNING
Harman® • Allure50 Installation Manual_R2 • 2016 - ___ • 09/16
Hearth & Home Technologies disclaims any responsibility
for, and the warranty will be voided by the following actions:
• Installation and use of any damaged appliance or vent
system component.
• Modification of the appliance or vent system.
• Installation other than as instructed by Hearth & Home
Technologies.
• Installation and/or use of any component part not
approved by Hearth & Home Technologies.
Any such action may cause a fire hazard.
!
Risk of Fire, Explosion or Electric Shock! DO NOT use
this appliance if any part has been under water. Call a
qualified service technician to inspect the appliance
and to replace any part of the control system which
has been under water.
WARNING
3-90-888000i