Display Panel - Pentax W-821NX Basic Instruction Manual

[Display panel]

Ñ Installation lamp
Ç Charge lamp
Power supply lamp (red): Turns on when the power supply is turned on.
Å
Charge lamp (green):
Ç
Discharge lamp (yellow): Turns on when you push the discharge button.
É
Installation lamp (red):
Ñ
Discharge button:
Ö
[How to charge]
It begins charging automatically when you set the battery packing in the charger which
Å
beams the power supply lamp.
Leave just as it is until the charge is completed.
Ç
When the charge is completed, the charge lamp is turned off.
É
Detach the battery packing from the charger when the charge is completed.
Ñ
[Refreshing the battery]
The use time shortens gradually by the phenomenon of "Effect of the memory" when the NiMH
battery leaves capacity and repeats the charge.The voltage recovers after refreshing and the use
time returns normally in such a battery. Please refresh one degree every five times of the charge.
[Refreshing]
Set the battery in the charger as well as the case of the charge. Push the electrical discharge
button. The electrical discharge lamp lights and the electrical discharge begins.
The electrical discharge lamp is turned off when the electrical discharge ends, the charge lamp
lights, and the charge starts automatically. Leave just as it is until the charge is completed. When
the charge is completed, the charge lamp is turned off. Detach the battery from the charger.
[Time of refreshing and charge]
Battery BP02 is discharged from the state of a full charge at about 960 minutes and the charge
is completed from the electrical discharge at about 130 minutes. However, the electrical dischar-
ge time is proportional to the remainder capacity of the battery. Moreover, the time required for
refreshing might be different from the above-mentioned time according to a surrounding tem-
perature and the state of the battery.
Turns on while charging and turns off when the charge is
completed.
Turns off when the discharge is completed.
Blinks or turns on when the battery packing is attached
normally.
Blinks when charge or discharge and turns on when charge is
completed.
(The charge lamp in the lower does not blink and does not
turn on)
Discharge lamp lights when you push this button, and the
discharge of battery begins.
13
Å Power supply lamp
É Discharge lamp
Ö Discharge button