Operation - King Canada 8352 Instruction Manual

TURNING THE SANDER ON AND OFF
1. To switch on the machine press the switch trigger (1).
2. To switch off the machine, release the switch trigger (1).
3. To switch the machine to continuous mode, keep the switch trigger fully pressed and
simultaneously press the lock on button (2) and subsequently release the switch trigger.
4. To switch off continuous mode, release the switch trigger.
Warning: Never use the machine for sanding magnesium work piece.
INSTALLING SANDPAPER
Your sander is designed to use 1/3 sheets of sandpaper. This size can be made by cutting a
full sized (9" x 11") sandpaper into 1/3 sheets of 8-3/8" x 3-1/2"
Install sandpaper to your sander as follows;
1. Soften the stiff edges of the sandpaper to be clamped (8-3/8" edge) by pulling it over the
90° edge of a table or other straight edge.
2. Release front clamp lever by pushing it in against the body, lifting it up slightly, then
pulling it out slightly and finally lowering it to disengage it from the tab on the base plate.
3. Fully insert the 8-3/8" edge of the sandpaper under the clamp and secure it by hooking
the clamp lever into the lock position behind the tab on the base plate.
4. Stretch sandpaper over the sanding pad and insert under the opposite clamp in the same
way.
Note: To use the dust extraction feature, perforate the sandpaper with the provided punch
plate as described in the punch plate instructions in the next section.

OPERATION

1
2